Materials
- 12” Giant circle beam compass
- Chargers
- Paint
- Stencil
- Plaid Contact paper
- Scissors
- X-acto knife
- Tape
- Cutting board
- Sponge for paint
Directions
Cut out a square of contact paper slightly larger than the charger
Tape down the sides of the contact paper to a work surface
Use the compass to create a circle on the backside of the contact paper for where you would
like be contact paper to go on the charger; then use the compass to measure a smaller circle
for the how wide the circle will be, so it will create the border for the charger
Use an x-acto to cut out the circle on a cutting board
Carefully remove the back of the contact paper and stick it to the charger
There will most likely be a bubble in a section of the contact paper when it it attach, use a pair
of scissors to cut that area (choose a place that doesn’t have much of a design on it) and then
press it back on the charger to seal
Place the desired stencil into the center of the charger and use the sponge to apply paint to
the stencil, careful to not spread the paint, just press it lightly
Carefully remove the stencil and allow the paint to dry completely
