Materials
- 1x6 Boards
- 3” AVC pipes
- 3” AVC Caps
- Gorilla Glue
- PVC Glue
- 1” Screws
- Measuring Tape/Ruler
- Drill
- 2” Eyelets
- Rope with hooks
- Pipe Insulation
- Colorful Duct Tape
DIY Wrestling Bed - Home & Family
Directions
1. 1x10 Board Cut To 82” (Just Beyond The Length Of A Twin Bed)
2. 3”AVC Pipes Cut to 54”
3. Measure 1 Inch In From Corner on Boards
4. Glue And Screw AVC Cap To Board Using Gorilla Glue and 1” Screws
5. Coat Bottom of AVC Pipe with PVC Glue Slide into Cap
6. Repeat 1-4 For Second Pipe
7. Repeat 1-5 For Second Board
8. Slide Boards Under Bed
9. Mark AVC Pipe At 6” And 18” From Top on a Diagonal
10. Pre-Drill Holes For Eyelets And Screw In Eyelets
11. Cut Pipe Insulation To Length Of Bungee Cords & Wrap Around The Cords
12. Wrap Pipe Insulation With Colorful Electric Tape
13. Hook Rope To Eyelets
Get more information about this episode >>
Check out more fun DIY projects at the Home & Family Pinterest Page