Materials
- Oval Craft Plaque
- Wood Buttons
- Pre-Made Wooden Heart
- 1/8 inch of wood
- Wood glue
- Decoupage glue
- Sandpaper
- Dremel tool & x-acto knife
- Wood stain
Directions
1. Measure your phone charger insert
2. Mark onto the center of the oval craft plaque
3. Use Dremel tool to insert pilot hole
4. Change drill bit to create a wider hole and make sure to carve out hole in a slant
Use wood glue on four wooden buttons & let dry
5. Use x-acto knife to cut a flat surface on the bottom of the premade heart
6. Optional (use sandpaper to smooth out the edges)
7. Use x-acto knife to cut out an angle shape from thin 1/8-inch wood piece
8. Use sandpaper to smooth all edges
9. Glue on triangle to heart & let dry
10. Glue heart with triangle piece onto wood plaque in the center & let dry
11. Use stain wood finish & let dry
12. Print picture, trace heart shape one inch smaller than wood heart
13. Use decoupage glue onto picture and place on heart
14. Take cord and slide underneath plaque and staple cord onto base.
